Top Mounting. Euro SMITHS fitting five holes on 51 mm pitch circle diameter. Gasket supplied. The arm length is adjustable for tanks of depths/diameters between 203 mm and 610 mm. After adjustment the arm is secured clips and soldering. Fitting and wiring instructions are provided. You will need to run a wire from the sender to earth. For use with Smiths Classic Fuel Gauges. 12 volt. Resistance 20 ohms (Empty) to 220 ohms (Full). NOTE: The Euro scale is the reverse of the US scale. A low resistance (eg 20 ohms) will display EMPTY on the correct gauge, high resistance (eg 220 ohms) will display FULL.Incompatible senders or gauges will give incorrect - opposite readings.

Side Mounting. Standard SMITHS fitting six holes on 60.33 mm pitch circle diameter. Gasket supplied. The arm length is adjustable for tanks of depths/diameters between 203 mm and 610 mm. After adjustment the arm is secured with clips and soldering. Fitting and wiring instructions are provided. You will need to run a wire from the sender to earth. For use with Smiths Classic Fuel Gauges.12 volt. The resistance range is approx 20 ohms (Full) to 260 ohms (Empty) - sometimes called the US/American scale. "Bimetal" characteristic. See fitting instructions.

Top Mounting. Standard SMITHS fitting six holes on 60.33 mm pitch circle diameter. Gasket supplied. The arm length is adjustable for tanks of depths/diameters between 203 mm and 610 mm. After adjustment, the arm is secured with clips and soldering. Fitting and wiring instructions are provided. You will need to run a wire from the sender to earth. For use with Smiths Classic Fuel Gauges. 12 volt. The resistance range is approx  20 ohms (Full) to 230 ohms (Empty) - sometimes called American scale. Suitable for Bimetal type gauges. Please see installation instructions to check suitability for your vehicle.

New fuel tank float/slide type gauge. Of the pattern offered by Rotherhams of Coventry for many years; fitting into the top of the fuel tank. A deeper float is fitted which works in the modern fuels. The float travels on a brass spiral centre shaft directly connected to the needle, which turns through 180 degrees. Marked Empty 1/4 1/2 3/4 Full, with silver dial with black figures. All brass construction and made to order. Please indicate the length required from the face of the tank flange to the tank depth - minimum gauge length about 20cm - maximum length 70cm).  We can offer two flange variations: hexagonal flange (originally for petrol) - measures 60mm across hexagon flats and threaded under at 2" x 16TPI, OR circular flange (originally for oil) - measures 63mm diameter, with 3 drilled screw fixing holes at 48mm centres. The base for the slide rods measures 44.5mm diameter. Please allow for a long delivery - due to the fact that these excellent gauges are made to order. Please also ensure that the details and dimensions you supply are correct, as the gauges cannot be returned for credit or refund. We will also require full payment when the order is placed. Delivery can extend to 6 or 8 weeks.  Gauges made longer than 500mm deep will be subject to an additional cost to that stated - please enquire.